RetroSound® Newport 1.5 DIN Direct-fit Radio

Newport Radio



The RetroSound® Newport is a direct-fit replacement radio for 1974-00 Mopar, 1982-02 GM and 1979-91 Ford vehicles that came equipped with a standard 1.5 DIN factory radio. The Newport looks and fits like the original factory radio, but boasts the most modern technological features. An Apple Made-For-iPod®/iPhone® interface is built in, as is Bluetooth® connectivity for hands-free phone calls and wireless audio streaming. The Newport features a dual color (amber or green) display and backlit buttons. Two USB ports for iPod®/iPhone® or flash drive (one on the front panel and one in the rear) plus two standard auxiliary inputs are included. The Newport has a built-in 25 watts x 4 channel MOSFET power amplifier as well as front and rear RCA pre-outs - plus subwoofer output - to add external amplifiers. It mounts seamlessly into your vehicle with the included mounting hardware and wiring harness. Until now, the only solution for vehicles with a 1.5 DIN opening has been to install a standard DIN-sized radio - an installation that looks awkward and out of place. Now you can have the most modern features without sacrificing the looks of your classic ride.

Note: If your vehicle came equipped with a Delco/Bose audio system, an adapter may be needed to use the Newport with your amplified factory speakers.

  • Direct-fit 1.5 DIN solution
  • Made-For-iPod®/iPhone®
  • Built-in Bluetooth® connectivity
  • Dual-color (amber or green) display and back-lighting
  • AM/FM RDS tuner with 30 pre-sets
  • Two rear-mounted USB ports for iPod®/iPhone® or USB flash drive
  • Two auxiliary inputs for portable devices
  • 25 watts x 4 channel RMS MOSFET power amplifier
  • Dual RCA pre-outs plus subwoofer output for external amplifiers
  • Installation kit and wiring harness included




SPECIFICATIONS

For more information, see the user's manual, or browse our support page.

FM

Tuning Range (EU and US tuning capable) with RDS 87.5-107.9MHz
Antenna Terminal External Antenna Connector
Usable Sensitivity 12.5 dBf
Selectivity 75 dB @ 400kHz
Signal to Noise Ratio 62 dB (Stereo), 67 dB (mono)
Harmonic Distortion @ 1 kHz 0.8% (stereo), 0.5% (monaural)
Separation 32 dB @ 1kHz
Frequency Response 30-16,000 Hz

AM (EU and US Tuning Capable)

Tuning Range (USA, EUR, AUS, JAP, RUS tuning capable) 530-1710 kHz
Antenna Terminal External Antenna Connector

General

Dimensions (radio face only) 8.10”W x 3.61” H x 1.29” D
Dimensions (radio body) 3.96”W x 1.98”H x 4.30"D
Power Requirements 10.5-14.4 volts
Current Consumption (during operation) Max. 15A
Current Consumption (car off) <3.5 mA
Output Power (@ 14.4 volts @ 4 ohm @ 1% THD) 25x4 watts RMS 45x4 Max Power
Output Impedance 4-8ohm
Low Level Output (4 channels) 2.85 volts
AUX 1 Input (front panel) >300 mV / 6 kΩ
AUX 2 Input (Aux cable length, 8" >300 mV / 6 kΩ
USB 1 Input (front panel) 5V (USB female input)
USB 2 Input (rear, USB cable length, 40") 5V (USB female input)